ADDING SMART+ WIFI CAMERAS

a) Auto scan mode

SMART+ WiFi cameras can only be added with the manual mode. Therefore, you need to click the link at the bottom of the screen which says, “click here to switch to manual adding process”, if you are already in auto scanning mode. This can also be done with the “add manually” button shown on the “info” button.

b) Manual adding mode

Select the device category tab “WiFi devices”. Then select the category “Smart camera”. In the next screen, select the WiFi router with 2.4 GHz network and enter the corresponding password with which you want to connect your devices. If you have multiple WiFi routers at your home, then you can select the WiFi from “change WiFi network” as well. Now power on the device. After the device is switched on, a green signal led flashes rapidly to indicate that the booting process has started. After around 10 seconds, the green signal led flashes slowly to show that the camera is now ready to be connected to the network.  Here you can click “yes” in the screen which asks “is the device flashing”?  If the device is not flashing then you need to hold the reset button for 3 seconds (see instruction manual).
The next screen displays a QR code that needs to be held around 15 to 20 cm in front of the camera. After the QR code is scanned by the camera, it will emit an acoustic signal. Then it will be registered on the cloud, and it will be initialized. After the device is added successfully, then a message will be displayed that “the device is successfully added”.
If connection isn’t possible via QR code, you can try establishing a connection in slow-flashing mode (previously known as ap mode, hereafter referred as slow-flashing mode) by clicking “use other adding mode” option. You may need to perform a reset beforehand. The reset button needs to be pressed down continuously for around 3 seconds. If the device is flashing, then you can tap “yes” and connect with device hotspot. After tapping on "connect with hotspot", the wlan of the smartphone must be connected to the hotspot (LDV smart+-xxxx) of the camera via the WiFi settings of the smartphone, you need to confirm with the “yes” button that the connection was successful. In the next step, a search will be carried out for that device. After the device is added successfully, then a message will be displayed that “the device is successfully added”.
 
c) Product functions

Tap one of the camera icons to display the device screen to control its functions. Different functions are displayed depending on the model and respective features of the camera.
 
  • Take a photo: to capture a photo of the current camera view.
  • Record a video: to record a video of the current camera view.
  • Siren: to start an acoustic alarm present in the camera.
  • Microphone: to use the microphone connected to the speaker in the camera.
  • Time schedule: to set a time schedule for the light, SD card recordings and motion detection.
  • Brightness: to set the brightness of the light source present in the camera.
  • Recordings: to view the recordings already saved by the camera.
  • Motion detection: to detect whether a motion is happening around.
  • Detection settings: to set the daylight sensitivity, sensing distance for different settings.